Makerbase Mks Dlc V21 Manual Link ⭐ Limited

Ensure you have the CH340 driver installed on your computer.

Used to trigger a spindle motor or an external relay for heavy-duty spindles. 4. Endstops (Limit Switches)

Whether you are building a new laser or upgrading an old one, finding the correct documentation is crucial. This article provides the necessary , wiring guides, and firmware instructions to get your machine running efficiently. 1. MKS DLC V2.1 Manual and Technical Resources

Once connected via USB (usually at ), you may need to adjust these settings in the console: $100, $101, $102 : Steps per mm for X, Y, and Z. $32=1 : Enable Laser Mode (if using a laser).

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. makerbase mks dlc v21 manual link

Your steps/mm settings ($100-$102) are incorrect. Calculate your steps based on your lead screw pitch or belt pulley size.

The MKS DLC v2.1 works with any standard GRBL-compatible control software:

The V2.1 typically comes pre-flashed, but if you need to update it, visit the MKS-DLC Github.

: Detailed PDF schematics and board layout images to help with connection setups. Ensure you have the CH340 driver installed on your computer

Understanding the hardware limits of your board prevents permanent damage to the circuitry. Here are the core specifications of the MKS DLC V2.1: ATmega328P (8-bit) Input Voltage: 12V to 24V DC Firmware Support: GRBL V1.1

: For WiFi‑based control (web or mobile), the MKS DLC32 requires the appropriate firmware version. The CNC firmware versions, for example, may lack the WiFi interface entirely.

Use XLoader to upload the .hex firmware file. Set the baud rate to 115200 or 57600 depending on the specific GRBL version.

Interfaces with MKS TS24, TS35, or generic LCDs for offline control. Safety: Supports X/Y axis limit switches (endstops). 3. MKS DLC V2.1 Wiring Guide Endstops (Limit Switches) Whether you are building a

Use a USB cable to connect the MKS DLC V2.1 to your computer. 5. Troubleshooting Common Issues

The manual includes a diagram of the jumper caps near the driver sockets. For TMC2209 in UART mode (default), you must place jumpers as shown in . Missing these will force the drivers into legacy standalone mode, causing missed steps and audible grinding.

The board includes dedicated ports for X, Y, and Z limit switches.