Your heater features two primary dials on the front control panel: OFF: Completely shuts down the heating elements.
: For a physical or PDF copy, users often find them on secondary marketplaces like eBay.
Carefully remove the heater, the two U-shaped metal brackets, four wing nuts, and the two caster wheel assemblies from the box. on a soft cloth or carpeted surface to avoid scratching the paint. Step 2: Position the Brackets
Provides moderate warmth for smaller spaces or milder days. patton heater model poh2501 manual
Always unplug the heater when it is not in use or left unattended. Avoid Wet Areas:
If possible, place the unit back inside its original box or cover it with a plastic sheet to prevent dust accumulation during the spring and summer months. 7. Troubleshooting Guide
Leave the dial at this position. The heater will now automatically cycle on and off to maintain this specific room temperature. Turning the Heater Off Turn the to the OFF position. Turn the Thermostat Control Dial fully counter-clockwise. Your heater features two primary dials on the
Check your home breaker panel; reset the breaker or replace the fuse. Thermostat is set too low. Turn the thermostat dial clockwise to a higher setting. Tip-over switch is engaged. Ensure the heater is resting flat on a hard, level surface.
Patton has been in the appliance business for decades. If your POH2501 is older than 10–15 years, check the manufacturer label. Older utility heaters lack the now required by UL standards (UL 1278). If yours doesn't have a weighted switch on the bottom, never leave it unattended.
A: That is the sound of the oil heating up inside the unit. It is normal. on a soft cloth or carpeted surface to
Wind the power cord loosely around the built-in cord wrap hooks if available. Do not wrap the cord tightly around the metal body.
Keep combustible materials—such as furniture, pillows, bedding, papers, clothes, and curtains—at least 3 feet (0.9 meters) away from the front, sides, and rear of the heater.
The Patton Model POH2501 is a fan‑forced utility heater designed for rugged environments like garages, workshops, and basements. Its durable all‑metal housing and oversized carry handle make it highly portable and resistant to the wear and tear of a workshop or job site.
: Always place the heater on a flat, level surface at least 3 feet away from combustible materials like curtains or furniture.