A salt bridge forms when a hard crust creates an empty cavity underneath the top layer of salt. The system appears full from the top, but the water underneath cannot dissolve the salt.
24,000 grains of hardness removal before requiring regeneration.
Beneath the top layer of fresh pellets, the salt had fused together into a solid, hollow crust. While the display insisted the tank was "Full," the water below was never actually touching the salt. The sensors were confused, trapped in a loop of reading a high salt level while the house’s pipes began to fill with the harsh, mineral-heavy water he had spent hundreds of dollars to avoid. Elias began to carefully break the crust, the crunch-crack
By following the information provided in this article, you'll be well on your way to ensuring your 40278 water softener continues to provide you with clean, soft water for years to come. 40278 water softener full
A "full" brine tank is a happy tank, but too much salt can lead to "mushing" (salt dissolving into a sludge).
If the brine line (the tube inside the brine well) has a leak or the safety float is stuck, the system cannot create the suction to pull the water 1.2.1.
When water enters the brine tank but cannot exit during the regeneration cycle, it causes a structural backup. The most common points of failure include: A salt bridge forms when a hard crust
Can reduce up to 10 ppm of ferrous iron and soften water up to 90 grains per gallon .
While the 40278 water softener is a reliable appliance, it can experience issues. Here are some common problems and their solutions:
Pull the float assembly out and clean it. Ensure the float rises and falls freely in its cage. 5. Excessive Water Pressure Beneath the top layer of fresh pellets, the
| Symptom | Probable Cause | Solution | | :--- | :--- | :--- | | "Full" but water is hard | Power outage reset the clock | Reset the time of day. The unit regenerates based on time, not just usage. | | "Full" constantly | Salt bridge (crust layer in brine tank) | Break up the crust with a broom handle. Do not use a sharp object. | | "Full" and motor runs constantly | Jammed piston or gear | Unplug for 30 seconds. If noise persists, call support. | | Brine tank overflowing | Damaged float switch | Replace the brine well assembly (part # for 40278: FX187B). |
filters up to 10 ppm), the tiny holes in the venturi can clog. When it clogs, water flows into the tank but cannot be drawn out . 2. Kinked, Blocked, or Elevated Drain Line