exit or end – Moves up one level in the command hierarchy or exits the session. 3. Essential Show Commands for Status and Monitoring
ssh admin@192.168.1.200 "ethernet port stats 1/2"
Ericsson CLI allows abbreviations as long as the command is unique.
copy : Used to move files, such as copying configurations or software loads to/from an FTP server.
The heart of the MINI-LINK is the radio modem. These commands control TX power, frequencies, and link performance. ericsson mini link cli commands
The human-machine craft Beyond syntax, the Mini‑Link CLI rewards pattern recognition: experienced engineers learn which show outputs correlate with certain failure modes (e.g., a particular board status + temperature trend + error counters often indicates a failing power supply or fan). The CLI thus becomes an instrument for mental models of system behavior rather than a mere control surface.
These commands manage how data traffic is handled across the link.
GET ETH
The classic "turn it off and on again."
💡 : Use the ? key at any time to see available completions or the Tab key to auto-fill long command strings. I can provide more specific commands if you tell me:
Mastering the Ericsson MINI-LINK CLI transforms you from a GUI-dependent operator into an efficient, scriptable network engineer. Whether you are commissioning a new hop, troubleshooting fading, or automating backups across 100 sites, the commands covered here—from show radio performance to script apply —will give you granular control over your microwave transport network.
To start a fresh measurement period (often done before a test):
Example output: Service_1 Service_2 Management_VLAN exit or end – Moves up one level
show board status : Checks if a specific board is in service or in "repair mode".
show ip route : Views the current routing table to verify DCN connectivity.
admin> services create name=Backhaul_RAN admin> services add-ce name=Backhaul_RAN ce-id=1 port=1/2 vlan=100 admin> services add-radio-flow name=Backhaul_RAN radio-flow-id=5
show controller sdh 1 # LOS, LOF, OOF, B1/B2 errors copy : Used to move files, such as
RESET SYSTEM
