Jungheinrich Etv 216 Error Codes _hot_ Online
Battery temperature is too high, or a battery cell is faulty.
| Code | Description | Possible Cause / Solution | | :--- | :--- | :--- | | | Drive Controller Fault | General electronics fault. Requires connecting a Jungheinrich diagnostic tool (ProDiag) to read the sub-code. | | E 102 | Throttle Sensor Fault | The accelerator pedal (hall sensor) signal is out of range. Check the pedal connection or replace the sensor. | | E 104 | Seat Switch / Seatbelt | The truck will not drive. Check if the seat switch is engaged or if the seatbelt is connected (if equipped with interlock). | | E 110 | Phase Fault / Motor Connection | Check the cable connections between the drive motor and the controller (U, V, W phases). | | E 112 | Speed Sensor Fault | Fault in the impulse encoder/speed sensor on the drive motor. | | E 115 | Battery Voltage Too Low | Voltage dropped below the cut-off limit. Charge the battery. | | E 116 | Battery Voltage Too High | Occurs often if the truck is plugged in while the key is on, or if the battery is overcharged. |
To help your service technician get your ETV 216 back up and running quickly, please provide us with the , the truck serial number (found on the chassis plate), and what action triggers the code . This allows the technician to bring the correct replacement parts on the very first visit. Share public link
When did the error appear (e.g., during startup, while lifting, while braking)? Jungheinrich Forklift Truck Fault Codes DTC.pdf
If your ETV 216 displays a code, it typically falls into one of these categories: Operator & Safety Errors jungheinrich etv 216 error codes
Jungheinrich ETV 216 reach truck uses a four-digit event message system to communicate operational statuses and technical faults through the display. Error codes are generally categorized into operator-related warnings (e.g., seatbelt not fastened) and technical system faults (e.g., controller or sensor failures). Common Operator & Startup Error Codes
Issues involving the lift, tilt, reach, or side-shift mechanisms.
The Multi-Pilot or Solo-Pilot control lever is out of its calibrated neutral position upon startup.
Here are some common error codes you may encounter on your Jungheinrich ETV 216: Battery temperature is too high, or a battery cell is faulty
Always start with the simplest fix: clean connections, charged battery, and a system reset. Then, methodically move to sensor checks, harness continuity, and component replacement. Keep a logbook of recurring codes to identify chronic issues.
Turn off → wait 30 seconds → turn on. Some transient errors clear.
The control unit has lost track of the drive wheel's physical position. This prevents precise navigation and will usually lock out high-speed travel for safety.
The error code persists after a complete power reset and battery check. | | E 102 | Throttle Sensor Fault
Many electrical faults are caused by an undercharged or failing battery. Measure the battery voltage under load to ensure it meets the truck's specifications.
Broken CAN-bus wires, corroded connectors, or a failing control card.
2. Hydraulic and Lift Function Errors (0200 – 0299 Series)
4. Communication and Controller Errors (E-Codes or 500+ Range)