Harvey Hv3 Water Softener Installation Manual __top__ Jun 2026

The salt blocks sit in approximately 1cm of water in the salt chamber, dissolving slowly from the bottom. Once a block drops to about a third of its original size, another block can be placed on top.

: It emphasizes meeting local water supplier regulations and WRAS guidelines.

: Use WRAS-approved flexible hoses for the inlet and outlet. Remove the red protective caps from the softener before connecting. Drain & Overflow : harvey hv3 water softener installation manual

For more information on the Harvey HV3 water softener, including detailed specifications and troubleshooting guides, please refer to the manufacturer's website or contact a authorized dealer.

: Connect a separate hose to the white spigot on the side of the cabinet. This must run downhill through an outside wall to a visible point. 3. Commissioning & First Use The salt blocks sit in approximately 1cm of

⚠️ Do not use generic water softener instructions. The HV3 uses an upflow regeneration valve that must be configured correctly – incorrect plumbing can bypass the resin bed entirely.

Turn off the main incoming water stopcock and drain the nearest cold water tap. : Use WRAS-approved flexible hoses for the inlet and outlet

Locate the main line after your internal stopcock but before any branches feed your boilers or water heaters.