Taxi Claw Machine Manual - Toy

Always plug the machine into a grounded, three-prong outlet. Do not use adapter plugs or remove the grounding prong.

Check the wiring on the gantry switches. Ensure the ground wire is on the correct terminal (usually isolated from the other two). Claw Stuck Down:

Carefully roll the machine into its permanent location using the rear casters. Once positioned, use a wrench to extend the four adjustable leg levelers until the casters lift slightly off the ground. Verify the machine is level using a bubble level placed on the top glass. 2. Accessing the Interior

Rearrange prizes to make the machine look attractive and ensure they aren't stuck behind the dispenser hole. Monthly Maintenance toy taxi claw machine manual

: Check the nylon string holding the claw for fraying. Replace it immediately if it shows wear to avoid dropping the claw assembly.

To avoid downtime, the includes a maintenance log. Transform that into a monthly routine:

Do not use WD-40 , as it attracts dust and gums up the bearings over time. String and Cord Inspection Always plug the machine into a grounded, three-prong outlet

No voltage is reaching the claw. Check the wiring harness traveling up the string or verify if the coil fuse on the PSU has blown. Optical Sensor Error

Set the strong grip to trigger, for example, every 10th10 raised to the t h power game, ensuring a 10% payout rate. Final Thoughts

If the gantry moves perfectly but the claw does not close or drop, check the or the dedicated claw fuse on the power supply. A blown fuse prevents the 24V-48V burst required to energize the claw magnet. 6. Wiring Diagrams and Connectors Ensure the ground wire is on the correct

Clean the optical lenses inside the prize chute walls. Ensure no dangling prize tags or plush limbs are permanently blocking the beam path. Common Mechanical Issues

Toy Taxi Claw Machine Manual: Setup, Operation, and Troubleshooting

The heart of the Toy Taxi is its main printed circuit board (PCB), usually mounted on the inside wall of the lower cabinet. Modern Toy Taxi machines feature an LCD or LED display screen on the board accompanied by four programming buttons: , Up , Down , and Exit . Entering Program Mode Unlock and open the lower service door. Locate the motherboard and press the Menu button. Use the Up and Down buttons to scroll through the settings.

To initiate self-check, press and hold the "TEST SW" on the motherboard and switch on the power. 4. Claw Strength and Voltage Settings