Zkteco Ua300 Factory Reset !!top!! -

To deploy the device again, assign a new static IP address via the network settings menu, set up a new system administrator immediately to secure the device, and re-sync your user database using your attendance software.

Go to User Management, edit the Admin user, and remove the admin rights. Method 3: Hard Factory Reset (Physical Reset Button)

Go to the section and ensure the UA300 status shows as "Connected". Select the specific UA300 device from your list. Look for the Device Control or AC Parameters tab. Click on Clear Data or Initialize Device . zkteco ua300 factory reset

: All IP addresses, gateway configurations, and Wi-Fi/Ethernet settings will revert to default values.

I can provide tailored troubleshooting steps or guide you through re-linking the device to your software. To deploy the device again, assign a new

If the device is connected to your local network and you have administrative access to the management software, you can trigger a reset remotely. Using ZKTime.Net / ZKAccess 3.5 Open the ZKTeco software on your computer. Navigate to the or Device Management tab. Ensure the UA300 status indicator is green (Connected). Click on AC Parameters or Device Control .

Reassemble the housing and mount the device back to the wall. Post-Reset Configuration Steps Select the specific UA300 device from your list

Authenticate using your administrator fingerprint, badge, or password. Use the arrow keys to navigate to and press M/OK .

Ensure the UA300 status shows as "Connected" or "Online" in the device management tab. Select the specific UA300 device from your list. Look for the or AC Parameters panel.

Select or Reset (depending on your specific firmware version).