5482 Standard Pdf — Din

: Fixed at 30° , which balances manufacturing ease with load-bearing strength.

The by the German Institute for Standardization (DIN) many years ago. It was succeeded and replaced by the highly superior DIN 5480 series of standards.

: This is the current standard. It also uses a 30-degree pressure angle. However, its sizes are based on the module system, making it easier to design. din 5482 standard pdf

: External spline (A) with a nominal diameter of 22mm and 19 teeth.

If you cannot find the PDF but have a physical sample (a worn shaft or hub), you can reverse-engineer the spline using these steps: : Fixed at 30° , which balances manufacturing

: Sizes are determined using the metric module ( DIN 5482 vs. DIN 5480: The Critical Differences

I can provide the specific dimensions or technical guidance you need for your project. Share public link : This is the current standard

capacity of a specific spline size A comparison between DIN 5482 and ANSI involute splines Common failure modes of involute splines Din 5482 Standard

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.

: Pumps and motors often use DIN 5482 shafts.

Once you have the data (either from an archived PDF or reverse-engineering), what software can you use?