The SpeedStile FL utilizes an array of infrared beams to detect tailgating and unauthorized entry.
The Gunnebo SpeedStile FL is a premium speed gate designed for smooth pedestrian access control. Proper installation ensures building security, user safety, and equipment longevity. This comprehensive guide covers the technical specifications, site preparation, physical installation, and electronic integration of the SpeedStile FL series. 1. Technical Specifications and Dimensions
Place an object in the path of the glass wings while they are open. Attempt to force a close sequence via the controller. The wings must remain open due to the safety beam interruption.
The is more than a set of instructions—it is a precision engineering document. A successful installation hinges on three pillars: strict adherence to floor flatness, correct torque on anchor bolts, and diligent sensor calibration. gunnebo speedstile fl installation manual
After mechanical installation, the manual requires a sensor calibration routine.
A systematic check (see Section 5.2, "Checklist after installation") should be carried out after installation is complete, covering:
Concrete foundations must be fully cured and capable of supporting anchor bolts. Minimum concrete thickness should be The SpeedStile FL utilizes an array of infrared
Connect the incoming AC power mains to the internal thermal-magnetic circuit breaker terminal block.
1200 mm or 1400 mm (depending on model variant). Cabinet Height: 1020 mm (standard glass height varies). 2. Site Preparation and Flooring Requirements
Units must be perfectly parallel and correctly aligned for the optical sensors to function properly. Attempt to force a close sequence via the controller
All access control integration interfaces with the main controller board inside the master cabinet. Terminal Label Connection Type Open Direction A Dry Contact (Normally Open) IN2 / open B Open Direction B Dry Contact (Normally Open) GND Common Ground Reference Ground FIRE Emergency Fire Drop Dry Contact (Normally Closed) SYS_OK Turnstile Status Output Relay Output (NO/NC)
⚠️ If the glass wing has a smudge, it’s not yours. Wear gloves.
: Use concrete with a minimum resistance of fckcube 30N/mm² . The minimum bolting depth for anchors is 70mm .
All under-floor conduits for power and data must be cast into the floor or trenched precisely according to the specific model's footprint layout drawing. Environmental Conditions