How To Reset Epson L3250 Using Resetter Adjustment Program Verified -

: Temporarily turn off all antivirus software and Windows Real-time Protection before downloading or extracting the file, as these tools often incorrectly flag adjustment programs as threats.

on the screen. Wait a few seconds, turn the printer back on, and click Verification

Turn the printer back on. The red blinking lights should now be gone. Verified Alternative: Hardware Manual Reset

Temporarily turn off Windows Defender or any third-party antivirus. These programs often flag the resetter as a "false positive" and will block it from running. USB Connection: Ensure the printer is connected to your PC via a . The reset cannot be performed over Wi-Fi. Printer Status:

This is a common false positive due to the program's method of communicating directly with hardware. Temporarily disable your antivirus, run the tool, then re-enable it. However, always ensure the file came from a trusted source before doing so . : Temporarily turn off all antivirus software and

: A prompt will appear stating: "Please turn off the printer." Reach over to your physical control panel and press the Power button to shut down your machine completely.

Open the extracted folder and double-click the AdjProg.exe file.

A configuration dialogue window will flash: "Please turn off the printer."

Place the printer on a stable surface, turn it on, and connect it via USB. Wi-Fi is never supported by these low-level tools. Ensure no paper is loaded. The red blinking lights should now be gone

: Under the Maintenance tab, select Waste ink pad counter and click OK . Initialize :

A: No, the Resetter Adjustment Program is specific to certain Epson printer models, including the L3250.

Click the drop-down option and manually assign the specific port labeled with your printer's name (e.g., USB001 (L3250) ). Do not leave this configuration parameter set to "Auto Selection" .

Finding a clean, verified version of the resetter tool requires caution. Here are reliable approaches: USB Connection: Ensure the printer is connected to

: The power button, ink drop light, and paper sheet light flash simultaneously or sequentially on the physical control panel.

The alternating blinking red lights should now be gone, and the printer status should return to "Ready." Important Hardware Maintenance Warning

from the Model Name list. You can leave the port as "Auto Selection" or select the specific USB port connected to your printer. Enter Adjustment Mode : Click on Particular Adjustment Mode Find Waste Ink Counter : Under the Maintenance section, select Waste ink pad counter Check Counter Status Check the boxes for Main pad counter Platen pad counter Ink system pad counter (options may vary slightly by version). button to verify that the counter has reached 100%. Initialize Reset Ensure all the same boxes are checked again. Initialize button. A prompt will appear; click to confirm. Power Cycle

: Locate the AdjProg.exe (or "Epson Resetter PH") file, right-click it, and select Run as administrator .

Resetting the waste ink counter using an Adjustment Program bypasses Epson’s safety feature. The waste ink pads physically fill over time and can leak ink inside your printer or onto your desk. After resetting, you should (or install an external waste ink tank). Proceed at your own risk.

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. HOW TO RESET EPSON L3250 | SERVICE REQUIRED