Simco Fmx002 Manual Top //free\\ Jun 2026

: Always turn the unit off after use to preserve battery life; many models feature an auto-off function after several minutes of inactivity. FMX-004 - Simco-ION

: The manual warns that HOLD does not freeze the internal zeroing circuit. If you press HOLD and then move the meter to a highly charged area, the stored value remains, but the internal sensor may drift. Always release HOLD before re-zeroing.

Simco-Ion recommends professional calibration once a year to ensure the unit remains within factory specifications. 6. Safety Warnings simco fmx002 manual top

Powering On and ZeroingPress the "POWER" button once. Before taking a measurement, you must zero the meter to account for ambient static. Aim the sensor at a grounded surface or into the air away from charged objects and press the "ZERO" button. The display should read 0.00.

) from the surface. It utilizes two LED guide ring lights that converge when the correct distance is reached. : Always turn the unit off after use

Located at the bottom of the unit. A grounding cable must be attached here to provide a reference point for accurate measurements. 3. Step-by-Step Operating Instructions

Mastering these steps is essential for repeatable results. Always release HOLD before re-zeroing

Before taking a measurement, point the sensor away from any charged surfaces and press the button. This ensures your baseline is neutral. Step 2: The Distance Rule (25mm) The is calibrated for a specific distance: exactly ( ) from the target surface.

The display shows up to 30.0 kV. If you see OL (Overload), you are too close to a very high charge (or the battery is low).

The sensor aperture is extremely sensitive. Never insert cotton swabs, cloths, or sharp objects into the sensor opening. Use low-pressure, clean, dry compressed air to blow out dust. Clean the exterior plastic housing with a damp cloth and mild detergent.

To comply with international quality standards such as ISO 9001 and ANSI/ESD S20.20, the SIMCO FMX-002 must undergo calibration verification every 12 months.